Keysight N9038A MXE Service Guide 621
Assembly Replacement Procedures
Input Connector Assembly
Replacement
1. Refer to Figure 18-66. Place the Input Connector Assembly into position in
the chassis. Replace the two screws (1) (0515-0372) to attach the Input
Connector Assembly to the chassis. Torque to 9 inch-pounds.
2. Reconnect the semi-rigid cable W25 to the Input Connector Assembly.
Torque to 10 inch-pounds.
3. Replace the Front Frame Assembly. Refer to the Front Frame Assembly
replacement procedure.
4. Replace the instrument outer case. Refer to the Instrument Outer Case
replacement procedure.
To Next Page
Loading...
