Field Description
Measurement com-
pleted
T
he percentage of collected data required for suc-
cessful processing. It is a conservative estimate
based on a 10 ‑ 15 km baseline. The criteria used to
display this value depend on the settings for Auto-
matically stop point measurement in Leica Capti-
vate - Home: Settings\Point storage\GS quality
control.
Time to go The estimated time in hours, minutes and seconds
until the configured stop criteria is reached. The cri-
teria used to display this value depend on the set-
tings for Automatically stop point measurement
in Leica Captivate - Home: Settings\Point stor-
age\GS quality control.
Next step
Page
changes to the RTK base page.
As shown below, the name of the page changes depending on the type of
base us
ed.
Name of page Description
RTK base page Base is a real base station.
Base (Nearest) page Base is the closest to the rover determined
by f
or example SmartNet.
Base (i-MAX) page Base information is individualised Master-
Auxiliary corrections determined and sent by
for example SmartNet.
Base (MAX) page Base information is Master-Auxiliary correc-
tions determined and sent by for example
SmartNet.
Base (VRS) page Base is a virtual base station.
Base (FKP) page Base information is area correction parame-
ters.
Description of fields
Field Option Description
Logging rate A time in sec The logging rate at the base. This informa-
tio
n is shown if the r
eal-time message for-
mat supports this information and raw
observations are being logged at the base.
----- Raw observations are not being logged, or
status information is not supported by RTK
format.
Next step
OK exits G
NS
S Data Logging Status.
GNSS Data Logging
St
atus,
RTK base page
Icon Pop-up Bubbles 41
To Next Page