Field Description
Ground marker to
antenna r
eference
point
•
Fo
r RTK data format: Leica, RTK data format:
Leica 4G, RTK data format: RTCM v3 or RTK
data format: RTCM 9,2 v2/RTCM 1,2 v2 with
RTCM version: 2.3:
The antenna height at the base from the marker
to the MRP.
•
For RTK data format: CMR/CMR+ and RTK
data format: RTCM 18,19 v2 or RTK data for-
mat: RTCM 18,19 v2 with RTCM version: 2.2:
The antenna height at the base from the marker
to the phase centre.
•
For all other RTK data format-----: is displayed
because the data format does not include infor-
mation about the antenna height.
Coordinates of The coordinates for the base station which are trans-
fer
red depend on the active real-time data format.
•
Fo
r real-time messages which include antenna
height and antenna type: Marker.
•
For real-time messages which do not include
antenna information: Phase Centre of L1.
Number of aux ref The number of active auxiliary base stations from
which data is r
eceived. Availability depends on selec-
ted network.
Antenna at base The antenna used at the base.
Sensor type at
base
The instrument type used at the base.
Next step
IF THEN
other coordinate types must be
viewed
Fn Coord. Local coordinates are
available when a lo
cal coordinate
system is active.
another page must be accessed Page.
this panel must be quit OK exits the panel.
This panel shows the status real-time connectivity as dynamic troubleshooting
panel. It shows the succ
ess of each of the steps in the connectivity to receive
real-time corrections. If one step fails or is skipped, the check box is
unchecked.
As each step is successfully completed, the check box is activated.
The page shows the status of the DynDNS connection.
This page is available, if DynD
NS is activated. Refer to "18.2 CS internet / GS
internet / TS Internet".
☞
Unavailable for CS35. Use the status panel in Windows.
RTK Data Link Status,
Connec
tivity page
RTK Data Link Status,
DynDNS page
46 Icon Pop-up Bubbles
To Next Page