4-74 Service Manual
5026
Note: When replacing either the front or rear cartridge guide wheel, be careful to not let the non-
defective cartridge guide wheel fall off.
Installation note: Inspect carefully if the cartridge guide wheel is seated properly on the cartridge
guide before reinstalling the screw on the cartridge guide.
Cartridge motor 1/fuser cable removal
1. Remove the LVPS. See “Low-voltage power supply (LVPS) removal” on page 4-127.
2. Disconnect the connectors in JCARTP1 (A) and JCARTS1 (B) on the system board.
To Next Page
Loading...
