Lexmark CS748de - Operator Panel USB Connector Cable Removal

4-142 Service Manual
5026
Go Back
Previous
Next
Operator panel USB connector cable removal
1. Remove the top access cover assembly. See “Top access cover assembly removal” on page 4-54.
2. Turn the top access cover assembly over.
3. Remove the eight screws (A) securing the position guide cover.
4. Disconnect the USB ground cable (B) and detach the USB cable connector (C) from the USB slot.
5. Remove the USB cable and ground cable from its retainers.
Installation note: Make sure to observe the routing of the USB cable.
A
B
C