4-154 Service Manual
5026
Warning: To avoid damaging the photoconductor drum, place the transfer module with the
photoconductor units on a clean surface. Never expose the photoconductor units to light for a prolonged
period of time. Place a clean, dry cloth over the transfer module and photoconductor units until they are
required.
8. Remove all of the toner cartridges.
9. Remove the right cover and the right side cover (attached). See “Right cover removal” on page 4-51.
10. Remove the LVPS. See “Low-voltage power supply (LVPS) removal” on page 4-127.
11. Remove the system board support shield. See “System board support shield removal” on page 4-168.
12. Push the top access cover down until it clicks into place.
To Next Page
Loading...
