Diagnostic aids 3-57
7562
5. Determine if the printer meets the skew specifications based on the values listed on the table.
6. If the printer does not meet the skew specifications, then go to “REGISTRATION” on page 3-11 to adjust
the base printer registration.
7. If the printer meets the skew specifications, then measure the scanner skew and determine if it meets the
skew specifications.
Scanner paper tray guides
In the scanner, the only parts that align the paper are the tray guides (A). The media is free to skew if the guides
are too tight or too loose.
Skew Specification
(L2-L1) (R2-R1) (T2-T1) (B2-B1)
Letter <
1.4 mm <1.4 mm <1 mm <1 mm
A4 <
1.5 mm <1.5 mm
Legal <
1.8 mm <1.8 mm
To Next Page
Loading...
