Repair information 4-125
7562
4. Slide the left side of the printhead toward the back of the printer until the bottom of the coarse alignment
screw (B) stops against the ridge in the printer frame.
5. Attach the three mounting brackets loosely to the printhead.
Note: Do not tighten the six screws in the mounting brackets yet. The printhead needs to be able to move
as you align it.
6. Align the printhead to the printer frame until the gaps between the printhead and the four slots in the frame
are as equal as possible.
7. Enter the Diagnostic menu (press and hold 3 and 6, turn on the printer, and release the buttons when the
splash screen appears).
8. From the Diagnostic menu, navigate to:
REGISTRATION > Quick Test
An alignment page prints.
Note: If you cannot see the triangles on the top of the test page, go to “Top Margin” on page 4-128, and
adjust the top margin until the triangles are visible.
To Next Page
Loading...
