4-126 Service Manual
7562
9. Use a flat-blade screwdriver to adjust the coarse alignment screw (C) until the triangles on the sheet are
parallel to the edges of the paper. Turning the screw clockwise moves the left triangles lower and the right
triangles higher (tilts the printed image to the left on the page). Turning the screw counterclockwise
requires pushing the printhead in the direction of the arrow as shown, for the printhead to move.
10. Reprint the alignment page and continue adjusting the screw until the black plane is aligned.
11. Once the black plane is aligned, tighten the screws in the right two printhead brackets (D), and then turn
the coarse alignment screw a half turn counterclockwise.
12. Attach the front bracket, and tighten the screws (E).
13. Reprint the alignment page and adjust the screw if necessary.
C
Push the printhead here.
To Next Page
Loading...
