Lexmark X792 - Page 827

Parts catalog 7-69
7562
Go Back
Previous
Next
40X7168
(Cont.)
10J0937 Thermistor &
redrive cable
Behind fuser
System board connector:
JFSRD1
See “Fuser thermistor removal”
on page 4-66.
10J0939 HVPS cable Under HVPS board
•System board connector:
JHVPS1
See “High-voltage power supply
(HVPS) board removal” on
page 4-67.
10J0942 Input option
cable
Bottom frame
•System board connector:
JIOPT1
1. Remove the bottom plate of the
printer. See steps 1 through 5 of
“MPF breakaway assemblies
removal” on page 4-95.
2. Push the cable up through the
frame.
3. Stand the printer back up, and
remove the cable
Note:Use cable ties to attach the
toroid to the new cable.
10J0947 Ground strap
cable
Front system board cage
support above LVPS
1. Remove the rear cover. See
“Rear cover removal” on
page 4-23.
2. Remove the strap from the top of
the LVPS.
10J0948 Duplex door
beacon cable,
side
Behind LVPS exit duct,
through left rear frame to left
access door
•System board connector:
JDDLED1
See “LVPS exit duct removal” on
page 4-84
and
“Left cover removal” on
page 4-16.
10J0949 Ref edge
ground cable
Staging paper path reference
edge
See “Staging paper path
reference edge assembly
removal” on page 4-140.
10J0951 Paper path
redrive sensor
cable
Paper path redrive
• System board connector:
JRDR1
See “Paper path redrive assembly
with sensors removal” on
page 4-116.
10J0953 Blower & right
side waste
cable
Behind blower, on top frame
under printhead access cover
•System board connector:
JBLW1
See “Printhead access cover
removal” on page 4-22.
10J0957 Duplex unit
cable
Behind LVPS exit duct,
through left rear frame to left
access door
•System board connector:
JDP1
See “LVPS exit duct removal” on
page 4-84
and
“Left cover removal” on
page 4-16.
10J0967 Waste toner
full cable
•System board connector:
JWTBF1
See “Waste toner full cable
removal” on page 4-167.
40X7170 10J0943 Waste toner
cable
Under lower frame cable cover
•System board connector:
JWTB1
See “Waste toner cable removal”
on page 4-165.
10J0950 Bin-full sensor
cable
Top cover
•System board connector:
JTCVR1
See AIO cavelight cable in “OP
panel cables removal” on
page 4-110.
10J0960 Front door
beacon cable
Waste toner left cover See “Waste toner left cover
removal” on page 4-31.
Cable location table
P/N item number Description Location To access