Lexmark X792 - Page 851

Index I-7
7562
Go Back
Previous
Next
paddle drive gear 4-344
paddle drive motor assembly 4-345
rear cover 4-346
sensors
bin-full receive
4-348
bin-full send 4-349
finisher bin media present 4-350
paddle HP 4-351
stapler access door interlock 4-352
stapler pass thru 4-352
tamper HP left and right 4-354
standard output bin LED and LED lens 4-355
stapler unit assembly 4-360
tamper drive belt 4-356
tamper drive motor assembly 4-357
tamper recoil spring 4-358
top cover 4-359
removals, HTU
access door
4-361
access door paper jam beacon (with cover and cable)
4-362
access door rollers 4-363
bin diverter gate spring 4-365
bin media exit spring 4-366
card (bin-full receive card and lens) 4-367
card (bin-full send card and lens) 4-368
controller card 4-369
drive belt 4-370
drive gear spring 4-371
engagement roller 4-372
exit roller 4-373
front redrive cover 4-373
front standard bin cover 4-374
HTU to printer cable 4-409
locking lever 4-375
locking lever card 4-377
lower redrive guide 4-377
option hook 4-380
option roller 4-382
outer front cover removal 4-391
output bin 4-383
output bin extension 4-384
output bin solenoid 4-385
output bin wire stop 4-386
output option guide 4-389
output option solenoid 4-390
output sensor 4-391
rear redrive cover 4-392
rear standard bin cover 4-394
right bottom cover 4-397
right inner cover 4-398
sensor cable (bin-full send and receive) 4-407
sensors
access door interlock
4-402
empty bin 4-403
input 4-404
output option position 4-405
second 4-406
stopper diverter 4-407
timing belts (rear) 4-408
top redrive cover 4-410
top right cover 4-411
transport gear 4-412
transport motor 4-413
upper exit shaft removal 4-414
upper guide 4-415
removals, stacker
access door beacon LED and beacon housing
4-332
bin-full spring 4-333
bottom cover 4-334
controller card assembly 4-335
feed roller 4-336
front cover 4-337
LED sensor cover 4-338
left access door assembly 4-339
option cable 4-342
output bin extension 4-343
output bin LED and LED lens 4-343
paddle drive gear 4-344
paddle drive motor assembly 4-345
rear cover 4-346
sensors
bin-full receive
4-348
bin-full send 4-349
finisher bin media present 4-350
paddle HP 4-351
tamper HP left and right 4-354
tamper drive belt 4-356
tamper drive motor assembly 4-357
tamper recoil spring 4-358
top cover 4-359
Reports 3-31
Reset Calibration 3-26
Reset Calibration Values 3-14
Reset Separator Roll and Pick Assembly Counter 3-30
right cover
removal
4-26
S
S1 sensor
removal
4-137
safety information ii-xxiii
safety inspection guide 6-1
Scanner Calibration Reset 3-28
scanner exposure lamp
removal
4-222
scanner fan filter
removal
4-220
scanner FB length sensor cable
removal
4-224
scanner front cover
removal
4-213
scanner interface card
removal
4-233
scanner left side front cover
removal
4-214
scanner left side rear cover
removal
4-214
scanner platen glass cover