Lexmark X792 - Page 852

I-8 Service Manual
7562
Go Back
Previous
Next
removal 4-234
scanner reference LED
removal
4-235
scanner reference LED sensor cable
removal
4-235
scanner right side cover
removal
4-215
scanner top cover
removal
4-216
screw and retainer identification table 7-71
sensor (ADF document set)
removal
4-206
sensor (ADF media exit) fan bracket assembly
removal
4-208
sensor (ADF sheet through)
removal
4-209
sensor (ADF top door interlock)
removals
4-209
sensor (platen glass length)
removal
4-236
sensor (scanner hp)
removal
4-238
sensor (scanner HP) cable
removal
4-237
Sensor Test 3-19, 3-20
SCANNER 3-28
sensors
input sensor service check
2-179
narrow media sensor service check 2-179
near narrow media sensor service check 2-179
S1 sensor service check 2-179
sensors (D1, D2, fuser bubble)
removal
4-135
Serial Number 3-25
Serial Wrap Test 3-16
service checks
111.xx–114.xx—printhead error
2-76
121.xx—fuser error 2-79
140.xx—Autocomp motor error 2-95
142.xx—fuser motor error 2-78
150.01-150.22—duplex motor error 2-97
900.xx System software 2-158
950.00–950.29-EPROM mismatch 2-166
956.xx-system board failure 2-167
bubble sensor 2-170
dead printer 2-175
input sensor 2-179
narrow media sensor 2-179
near narrow media sensor 2-179
networking 2-189
S1 sensor 2-179
tray linking 2-200
service error
900.xx System software error
2-158
service tips
identifying system board cabling
5-1
setting printer alignment 3-12
SIZE SENSING 3-31
speaker
removal
4-113
specifications
acoustics
1-4
dimensions 1-3
electrical 1-4
environment 1-5
memory configuration 1-6
operating clearance 1-4
paper and media 1-6
power and electrical 1-3
time to first print 1-5
staging deflector assembly
removal
4-138
staging paper path reference edge assembly
removal
4-140
standard media tray
removal
4-148
Stapler Test 3-21
switch (ADF closed interlock)
removal
4-210
symptoms
500-sheet drawer option
2-75
base printer 2-75
HCIT 2000-sheet option 2-75
print quality 2-33
system board
cabling reference
5-1
connections 5-2, 5-3
removal 4-149
system board cage with board
removal
4-157
T
Toggle ITU 3-14
toner cartridge rail
removal
4-44
tools required 1-11
Transfer Adjust 3-27
Tray Insert Msg 3-31
tray linking, service check 2-200
troubleshooting flow 2-1
U
UICC card
removal
4-113
USB HS Test Mode 3-17
USB Scan to Local 3-30
W
waste toner container
removal
4-163
waste toner cover
removal
4-31
waste toner full sensor
removal
4-168
waste toner sensor
removal
4-164
waste toner tray bracket
removal
4-168