IPECS Release 5
Feature Description & Operation 5.0
2-89
Or,
1. Lift the handset or press the [
SPEAKER] button.
2. Dial ‘8#’, the Held CO/IP Call Access code.
3. Dial the CO/IP line number
SLT
To place a call on Exclusive Hold
1. Momentarily press the hook-switch.
2. Dial ‘560’, the System Hold feature code.
To access a call from System Hold
1. Lift the handset.
2. Dial ‘8#’, the Held CO/IP Call Access code.
3. Dial the CO/IP line number.
Conditions
1. When a CO/IP line is placed on System Hold, the button LED will flash at 30 ipm and wink at
the holding station and will flash at all other stations.
2. A call on System Hold can be retrieved from any station allowed access to the CO/IP line in the
system database using the CO/IP line button or the Held CO/IP call access code.
3. The LED of {
LOOP} and {POOL} buttons will display the CO/IP line status.
Programming
SYSTEM 1. Hold Preference (PGM 160-Btn 7)
2. Attendant Recall Timer (PGM 180-Btn 1)
3. I-Hold Recall Timer (PGM 180-Btn 5)
4. System Hold Recall Timer (PGM 180-Btn 6)
Related Features
Call Transfer, CO/IP
Hold Preference
Hold Recall
Exclusive Hold
Hardware
2.41.5 Automatic Hold
Description
While on an active CO/IP call, the system will place the call on hold automatically if the user presses
the [
FLASH], [CONF], {DSS/BLF} or other feature buttons. In addition, the station can be programmed
to support CO/IP to CO/IP Automatic Hold. In this case, pressing a CO/IP button while on a CO/IP
call will place the active call on hold and access the selected CO/IP line.
To Next Page
Loading...
