IPECS Release 5
Feature Description & Operation 5.0
2-139
Conditions
1. If both of transferred and transferred-to stations are located in the same system, the networking
path will be cleared. That is, the transfer call will be setup as intercom call.
2. The transfer will be canceled when user presses the flashing [CO] or [
TRANS] button.
3. Net Transfer call does not recall to the origination.
4. User hears an error tone if there is no idle networking path.
5. Net transfer is not activated to a busy station.
Programming
SYSTEM 1) Networking Basic Attribute (PGM 320)
2) Networking Supplementary Attribute (PGM 321 – BTN 1)
3) Networking CO Line Attribute (PGM 322)
4) Network Numbering Plan Table (PGM 324)
2.69.2.3 Identification Service
Description
Calling Name Identification Presentation (CNIP): When a user makes a net call and a name of
station is programmed in the Station Name field (PGM+74), the system includes the name of calling
party to the called party between systems.
Operation
1. A Net Call is arrived a station with LCD display.
While ringing, the CNI will be displayed if they are included in the Setup message.
Conditions
Programming
SYSTEM Network CNIP/COLP Enable (PGM 320 – BTN 3 / BTN 4)
2.69.2.4 Call Completion
Description
There are two kinds of call completion as follows;
Completion of Calls to Busy Subscribers (CCBS):
After calling a user in another system using basic call and encountering a busy tone. A station user
can be notified when the busy destination of another system becomes idle. If the user wants to
make a call to the destination on that notification, the call can be reinitiated to the destination of
another system again.
Completion of Calls on No Reply (CCNR):
To Next Page
Loading...
