IPECS Release 5
Feature Description & Operation 5.0
2-59
Hold Recall
Unsupervised Conference
Broker Call
Conference Room
Hardware
MCIM required to support voice conferences with more than 3 parties.
2.23.3 Unsupervised Conference
Description
An iPECS phone user may establish a conference with external parties and exit the conference while
allowing the external parties to converse privately without supervision from the user.
The system will disconnect the Unsupervised conference if disconnect is detected with only two
parties connected or at expiration of the Unsupervised Conference timer. Fifteen seconds prior to
expiration of the timer, a Disconnect Warning Tone is provided.
If enabled, either party in an Unsupervised Conference can request the Unsupervised Conference
timer be extended. The party enters the Timer Extension feature code and a digit 1 to 9 indicating
the Timer extension multiplier. The system will then extend the timer based on the dialed digit
multiple of the Timer. For example, if the Unsupervised Conference timer is 5 minutes and the user
dials the digit 4, the timer will extend to 20 minutes (4 multiplied by 5 minutes).
Operation
iPECS Phone
To set up an Unsupervised conference
1. Establish normal conference.
2. Press the [
CONF] button. The [CONF] button LED flashes to indicate the Unsupervised
Conference state.
To reenter the Unsupervised conference
1. Press the flashing [
CONF] button.
Conf Party
To extend the Unsupervised Conference from a connected party
1. Dial ‘# #’.
2. Dial the Timer extension multiplier (1~9).
Conditions
1. The Unsupervised Conference Timer also applies to an external call placed by a DISA user.
2. An Unsupervised conference will be terminated if the system receives a disconnect signal or
the Unsupervised Conference Timer expires.
3. An Unsupervised Conference will not recall the user.
To Next Page
Loading...
