IPECS Release 5
Feature Description & Operation 5.0
2-110
5. Press the [SAVE] button, confirmation tone is received, the new Custom Message is stored and
the station returns to idle.
Conditions
1. Only the System Attendant or Administrator can assign the contents of Custom Messages 11-
20.
2. The alphanumeric characters are displayed as they are entered; refer to Station Speed Dial for
entry procedures.
3. Display Message is cancelled if the user activates DND or Call Forward.
4. Custom Text Display Messages and Display Message status are stored in non-volatile memory
to protect against loss during power failure.
5. The calling station must be an iPECS or LG-Nortel digital phone with display to receive the
message.
6. SLTs are notified of an active Display Message with stutter dial tone. iPECS Phones will have
a flashing [
FWD] button when there is an active Text Display Message.
7. Activating a Text Display Message does not affect normal operation of the station.
8. Pre-defined Messages 01 to 04 and 06 to 08 permit the user to input auxiliary information such
as time, date or number.
9. The Attendant station can activate a Text Display Messages for other stations. However, this
feature is not available to an Attendant.
Programming
Related Features
Silent Text Message
DND (Do Not Disturb)
Call Forward
Speed Dial
Hardware
iPECS Phone required to receive Display Messages
2.60 REDUNDANT SYSTEM PROCESSOR
Description
The iPECS system supports redundant processor operation. The redundant system processor is a
hot standby processor. The LAN2 port of the master MFIM is connected directly to the LAN2 port of
the standby MFIM. The standby MFIM monitors the active MFIM and takes over system control if
the:
active MFIM power fails.
active MFIM is reset.
LAN1 connection to the active MFIM fails or is removed.
standby MFIM does not receive a polling message from the active MFIM for 1 minute.
To Next Page
Loading...
