IPECS Release 5
Feature Description & Operation 5.0
2-141
Conditions
1. Call Offer is only applied to a station that is in talk status.
2. During a conference or paging, call offer is not activated.
3. System does not support the path reservation mode of standard QSIG specification.
Programming
SYSTEM Networking Basic Attribute (PGM 320)
2.69.2.6 Net Conference
Description
A call to a station on one node is able to conference in a party on any other node. Members of
conference must be allowed up to 3 stations of the network.
Operation
To make a Net Conference
1. Press the [CONF] button during conversation through the network call.
The exiting call is on hold and an ICM dial tone is provided.
2. Make a Net Call to another station of other node.
3. Press the [CONF] button when 3’rd party answers.
The second call is on hold and an ICM dial tone is provided.
4. Press the [CONF] button again at master station. All parties can make a conversation.
To clear a Net Conference
1. Any station in the net conference hangs up during the conference.
The net conference will be cancelled and the network path will be cleared.
Conditions
1. Multi-line conference time is not applied on 3 party conference of networking.
2. Standard IP phone can not be a master station of the Net Conference.
Engineering notice)
When IP phone sends Invite Setup to Non-IP phone, this message will be rejected.
When Non IP phone is going to invite IP phone, normal Setup message should send to the IP
phone instead of Invite Setup message.
Programming
SYSTEM 1) Networking Basic Attribute (PGM 320)
2) Network Numbering Plan Table (PGM 324)
To Next Page
Loading...
