IPECS Release 5
Feature Description & Operation 5.0
2-151
5. Press the pre-programmed {NET DSS} button containing the Network Paging number of the
other System.
6. The Called party System will receive a digit stream sent by the Calling party; it will be analyzed
using the Network Feature Code Table to determine the appropriate destination. If the
destination is right, the Called system will distribute the page announcement to the Stations.
7. The [Network CO] button LED will be extinguished when the Net Page Call is cleared.
Conditions
1. Network Page code must be programmed in the Network Numbering Plan Table (PGM 324) in
the Caller System.
2. Network Page code and page destination must be programmed in the Network Page Table
(PGM 325) in the Called system.
3. Network Page destination could be Internal Page (MFIM100: 1-10,
MFIM300/MFIM600/MFIM1200: 1-35), External Page(1-2), All Call Page(Internal, External, All).
4. User will hear an error tone if there is no idle networking path or if the page destination is
invalid.
5. User can make a page announcement without lifting the handset.
Programming
SYSTEM 1. Networking Basic Attribute (PGM 320)
2. Networking CO Line Attribute (PGM 322)
3. Network Numbering Plan Table (PGM 324)
4. Network Feature Code Table (PGM 325)
2.70 TRAFFIC ANALYSIS
Description
The iPECS monitors, stores and periodically or upon request outputs various traffic statistics
covering system resources. The output from the system can be used to:
x Monitor and evaluate system performance
x Observe usage trends and recommend possible corrective actions,
x Determine possible trunk problems, i.e. blocking level too high, and/or
x Recommend system upgrades.
Attendants enable Periodic Reporting. Once enabled, the system continues to monitor and output
the requested report until Periodic Report is disabled. On-demand reports selected by the System
Attendant are output only upon request. The Traffic Report is sent to the defined system RS-232 or
TCP port.
System resources covered by Traffic Repots are:
x Attendant Traffic Report
x Call Summary Report
x Hourly Call Report
x H/W Unit Usage Summary Report
x CO Summary Report
x Hourly CO Report
To Next Page
Loading...
