LG IPECS - Message Wait;Call Back; CLI Message Wait

IPECS Release 5
Feature Description & Operation 5.0
3-8
3.9 MESSAGE WAIT/CALL BACK
3.9.1 CLI Message Wait
Description
When an iPECS Phone with display receives an external call with Calling Line Identification and
the call is abandoned (disconnects before answer), the system will generate a call log with the
Caller Identification, date and time. The user may employ this log to review and, if desired, return
the call.
An iPECS Phone user may assign a {
CLI MESSAGE WAIT} button with direct access to the CLI
Message Wait list. The button LED flashes at 30 ipm to indicate a CLI Message Waiting.
Operation
iPECS Phone
To assign a {
CLI MESSAGE WAIT} button
[
PGM] + {FLEX} + [PGM] + 32 + [SAVE]
To review CLI Messages
1. Press the {
CLI MESSAGE WAIT} button, the first CLI message is displayed.
2. Press the [
VOL UP]/[VOL DOWN] button to scroll through the CLI Messages.
165.123.23.36
21/11 09:10 CNT: 2
To delete the current CLI Message
1. Press the ‘*’ button, the next CLI message is displayed.
To delete all CLI Messages
1. Press the [
SPEED] button.
2. Press the ‘*’ button twice.
To return a call to the current CLI Message
1. Press the [
SAVE] button.
Conditions
1. The total number of Message Wait indications in queue for the system is 1000. Should the
message Wait buffer fill, the buffer full message, as below will be output over the RS-232 port.
“Warning: Message Wait Buffer Full.”
2. The CLI Message Wait display includes the date, time, message count and CLI. The count is
the number of attempts by a specific calling party with the time and date from the most recent
attempt.
3. The CLI Message Wait status is stored in non-volatile memory to protect against power loss.
4. When a CO/IP call is assigned to ring multiple stations, or a group, CLI Message Wait is not
provided.
5. When a CO/IP call with CLI is routed to an ACD/Terminal/Circular station group, the CLI
Message Wait will be provided to the last station rung before the call was abandoned.