IPECS Release 5
Feature Description & Operation 5.0
2-145
2.69.2.10 Net Call Forward – No Answer
Description
It is possible for a user to forward his station remotely when the station does not answer within the
CFW NO ANS Timer. The forwarded destination can be over the network.
Engineering notice).
Currently, iPECS system supports both rerouting and join method by admin programming.
Operation
To activate Net Call Forward
1. Press the [SPEAKER] button and the [FWD] button.
2. Dial Net Call Forward code “3”, and dial the station number of another system.
The [FWD] button will be flashing and a confirmation tone will be provided if allowed.
3. Dial the station number that is set Net Call Forward to a station of another node.
The call is routed to a forwarded station when the called station does not answer within a No
Answer timer, and the forwarded station is ringing.
4. Answer the ringing at forwarded station.
The calling and forwarded station can make a conversation.
To deactivate Net Call Forward
1. Press the [FWD] button when it is flashing.
The [FWD] button will be extinguished.
Conditions
1. If both of served and diverted-to stations are located in the same system, the networking path will
be cleared. That is, the forwarded call will be setup as intercom call.
2. System does not check the status of diverted-to station that is in DND, CFW or Empty.
Programming
SYSTEM 1) Networking Basic Attribute (PGM 320)
2) Networking Supplementary Attribute (PGM 321 – BTN 1)
3) Networking CO Line Attribute (PGM 322)
4) Network Numbering Plan Table (PGM 324)
2.69.2.11 Net Call Forward – Busy / No Answer
Description
It is possible for a user to forward his station remotely when the station does not answer within the
CFW NO ANS Timer. The forwarded destination can be over the network.
Engineering notice).
Currently, iPECS system supports both rerouting and join method by admin programming.
Operation
To activate Net Call Forward
1. Press the [SPEAKER] button and the [FWD] button
To Next Page
Loading...
