LG IPECS - IP Bridge Mode

IPECS Release 5
Feature Description & Operation 5.0
2-93
To Active or Deactivate In-Room Indication button,
1. Check if Supervisor station is the idle state and In-Room Indication button is programmed.
2. Press In-Room Indication button and press [HOLD/SAVE] button.
Conditions
5. If Supervisor station is not Idle, In-Room Indication button does not work.
 If a station press the In-Room Indication button but the station is not supervisor, an error tone
is heard.
 If [HOLD/SAVE] button is not pressed within 5 seconds after In-Room Indication button
pressed, the station goes back to the Idle state.
Programming
SYSTEM 1. In-Room Indication (PGM 183)
Related Features
Hardware
2.45 IP BRIDGE MODE
Description
The Phontage and UCS client can automatically bridge the audio for a call to linked pair station.
When the Phontage or UCS client place a call in the bridged mode, the iPECS Phone is connected
to the call.
Operation
To use the IP Bridge mode:
1. Place a call from the Phontage or UCS client. The Phontage or UCS client must be in the
Bridged mode.
2. The call must be connected by lifting the handset of the linked iPECS Phone.
Conditions
1. The Phontage or UCS client must be used locally to the bridged iPECS Phone
2. Bridged operation must be selected at the Phontage or UCS client.
3. The Phontage or UCS Phone must be linked to the associated iPECS Phone.
4. Bridging is not available from the iPECS Phone to the Phontage or UCS client.
Programming
Related features
Linked Station Pairs
Hardware