IPECS Release 5
Feature Description & Operation 5.0
6-17
To terminate an alert signal while idle:
1. Dial the Alarm reset Code, 565, confirmation tone is received and the Alert terminates.
Or,
Press the {
ALARM STOP} button.
To view the Emergency Call History at the System Attendant phone:
1. Lift the handset or press the [
SPEAKER] button.
2. Press the [
PGM] button.
3. Dial ‘08’, the Emergency Log code. The display shows the first emergency call logged in the
history.
EMERGENCY STA NO XXXX
MM/DD HH:MM (xx)
4. Press the [VOL UP] and [VOL DOWN] buttons to scroll through the call history.
5. If you review a history then the item will be mared as below.
EMERGENCY STA NO XXXX
MM/DD HH:MM READ (xx)
6. If you review all history then the alarm will not provided when the station go to idle.
Programming
STATION 1. Emergency CO/Group (PGM 112, BTN 18)
T
ABLES 1 Emergency Code Table (PGM 226)
SYSTEM 1 EMR CALL ATD NOTIFY (PGM 161, BTN 24-6)
Conditions
Related Features
Alarm Signal/Door Bell
Emergency Call E-911 (caller location) Support
Emergency Call
Hardware
6.15 EZ-ATTENDANT
Description
The ez-Attendant is a Windows based PC application that provides a visualization of the Attendant
functionality to simplify Attendant control of features and functions including displays of call, user
and system status. ez-Attendant operates in conjunction with the Attendant’s iPECS Phone to
simplify operation and expand features and functions available to the Attendant.
For further information on ez-Attendant, refer to the ez-Attendant Installation and User Guide.
To Next Page
Loading...
