LG IPECS - Co Call Rerouting; Outgoing Mailbox Destination

IPECS Release 5
Feature Description & Operation 5.0
2-179
2.78 CO CALL REROUTING
Description
System can reroute incoming call to CO. If called number matched with compare digits of Table 252,
the call are routed to Rerouting number.
Operation
1) Enable Co Call Rerouting ON and Save
2) T-net FoPstn Table(333) is reduced and created new Col Call Rerouting table.
3) If Compare CO Group is not assigned, All incoming calls are compared with Compare digits.
4) If Compare Co group is 1 and incoming call is co group 2, it doesn’t work.
5) If Compare digits are 454**, called number should be 454xx(xx is any two digits).
6) Item [CO + Rerouting Number] : if co access code is ‘9’ and tel-number is 1234567,
91234567
7) Item [CO + Rerouting Number] : if individual co numbering code is 88 , co is 5 and tel-number
is 1234567, 880051234567
8) Item [CO + Rerouting Number] : if co group numbering code is 8 , co group is 3 and tel-
number is 1234567, 8031234567
9) If you want to reroute Net number, Rerouting Type should be set NET Type.
10) If you want to reroute internal station, Rerouting Type should be set DISA Type.
Conditions
1) Caution : If Co call rerouting table is used, Fop table(333) is reduced. And so, if you don’t
like to do it, you shoud not choice 252 table.
2) Tnet Fop table(333) and Rerouing table(252) is reduced as following by system capacity.
Fop table(333) Rerouting table(252)
50A/B, 100 : 100 Æ 20 Æ 80
300 : 200 Æ 30 Æ 170
600 : 300 Æ 50 Æ 250
1200 : 600 Æ 100 Æ 500
Programming
SYSTEM CO Call Rerouting (PGM252-Web only)
Tnet Fop Table(333)
Related features
Hardware
2.79 OUTGOING MAILBOX DESTINATION
Description
If a CO/IP incoming, Caller dials "0" when listening to a station’s VSF mailbox greeting the call is
routed according to the "Outgoing Mailbox Destination" as programmed for the station.