IPECS Release 5
Feature Description & Operation 5.0
2-174
2. Dial ‘562’, the SLT Programming code, confirmation tone is heard.
3. Dial ‘42’, the erase Wake-up code.
4. Hook flash, a conformation tone is provided.
Conditions
1. In cases where a remote device is installed, the time display in the remote terminal is adjusted
by the Device Zone assignment. Thus, the Wake-up alarm time is based on the time displayed
on the phone and not the system time.
2. When receiving a wake up signal, lifting the handset will return MOH.
3. The Wake-up alarm Ring signal is 30 seconds On/90 seconds Off repeated 3 times. If no
action is taken by the user, the ring signal is given to the Attendant with a display designating
the station number that did not respond.
4. Time (hh:mm) must be entered in the Military 24-hour format.
5. The daily alarm will reset and repeat each day until erased (cancelled). The One-time alarm will
reset and cancel automatically.
Programming
Related Features
Hardware
2.74 ZONE HOLIDAY ASSIGNMENT
Description
The Administrator can assign Holiday Zones (up to 40) and Vacation Zones (up to 5 for each Zone).
Devices in a Zone follow the holiday and vacation assignments of the zone. When the date of a
zone is set to Holiday or Vacation, the zone will operate in the programmed ring mode.
Operation
Operation of Zone Holiday Assignment is automatic when programmed.
Conditions
1. When the Tenancy group Ring mode for Flexible DID/ICLID function (PGM231) is programmed,
the priority is higher than the Zone Holiday Assignment (PGM444).
2. Zone Holiday Assignment has a higher priority than the Attendant ring mode.
3. It is recommended to use the same zone for each Tenancy group CO and station.
Programming
SYSTEM 1. Zone Holiday Assignment (PGM 444)
Related features
Hardware
To Next Page
Loading...
