IPECS Release 5
Feature Description & Operation 5.0
4-16
ISDN/ICLID 1. CLIP Print to Serial Port (PGM 200-Btn 2)
Related Features
Hardware
ISDN gateway Module
4.15.3 Keypad Facility
Description
The ISDN Keypad Facility Information Element (IE) may enable the user to activate certain ISDN
services (e.g. Off-Net Forward). To access this facility, the station must be enabled and have a
Flex button for {
KEYPAD FACILITY}. When activated, the digits dialed by a user are sent in the
Keypad Facility IE instead of the Called Party Number IE.
Operation
iPECS Phone
To program {
KEYPAD FACILITY} button;
[
PGM] + {FLEX} + [PGM] + ‘89’ + [SAVE]
To activate the keypad facility while on an ISDN line
1. Press the {
KEYPAD FACILITY} button.
2. Dial desired digits, other actions disable Keypad facility feature.
Conditions
1. This feature can be activated or deactivated only after a CO line (ISDN) is seized.
2. Once activated, the system will continue to send dialed digits as Keypad Facility IE
messages regardless of ISDN messages. Thus, in the connected mode, DTMF tones are not
sent to the connected party, only the keypad message is sent.
3. If a Speed Dial bin includes [
MSG/CALLBK] button as the first entry, the remaining digits in the
Speed Dial number will be sent in a Keypad Facility IE.
4. This feature may not be available in the specific ISDN or may be a subscription service.
5. The system can handle only a single Call Reference; services that require handling of two
simultaneous Call References, cannot be supported.
Programming
STATION 1. Flex Button Assignment (PGM 115)
Related Features
Station Speed Dial
System Speed Dial
Hardware
iPECS Phone
ISDN gateway Module
To Next Page
Loading...
