IPECS Release 5
Feature Description & Operation 5.0
2-146
2. Dial Net Call Forward code “4”, and dial the station number of another system.
The [FWD] button will be flashing and a confirmation tone will be provided if allowed.
3. Dial the station number that is set Net Call Forward to a station of another node.
The call is routed to a forwarded station when the called station does not answer within a No
Answer timer, and the forwarded station is ringing.
4. Answer the ringing at forwarded station.
The calling and forwarded station can make a conversation.
To deactivate Net Call Forward
1. Press the [FWD] button when it is flashing.
The [FWD] button will be extinguished.
Conditions
1. If both of served and diverted-to stations are located in the same system, the networking path will
be cleared. That is, the forwarded call will be setup as intercom call.
2. System does not check the status of diverted-to station that is in DND, CFW or Empty.
Admin Programming
SYSTEM 1) Networking Basic Attribute (PGM 320)
2) Networking Supplementary Attribute (PGM 321 – BTN 1)
3) Networking CO Line Attribute (PGM 322)
4) Network Numbering Plan Table (PGM 324)
2.69.2.12 CO Transit-In
Description
The incoming DID call can reroute to the net call destination that is in another system.
Operation
1. A DID call is arrived from PX.
There is no limit for selecting DID conversion type. According to the result of DID conversion, the
call will be routed.
2. Network CO line is seized automatically, and the call is transfer to the network destination.
The destination receives the ringing with CLI from PX.
The outside user still hears a ring-back tone.
3. Both the outside user and the destination station can make a conversation when the destination
station answers the ringing.
Conditions
1. Any timer is not assigned to the transit CO line.
2. Outside caller hears busy tone when a networking path is not available during transit.
Programming
To Next Page
Loading...
