IPECS Release 5
Feature Description & Operation 5.0
3-2
3. For ring-back tone, await answer or
For Intercom splash-tone, speak and await answer.
SLT
To place an intercom call
1. Lift the handset to receive ICM dial tone.
2. Dial station number.
3. For ring-back tone, await answer or,
For Intercom splash-tone, speak and await answer.
Conditions
1. Intercom dial tone will time-out if action is not taken within Dial-Tone Time or if the time
between digits exceeds the Inter-digit Timer. Error tone is received should a time-out occur.
2. ICM Dial tone is removed after dialing the first digit.
3. If the called station is busy, Intercom Busy tone is provided for the Busy Tone time (7
seconds) then, error tone is sent by the system. The caller may disconnect or activate a
feature such as Message Wait/Callback prior to the time-out.
4. For iPECS Phone users, consecutive Intercom calls can be placed without the need to regain
ICM dial tone (no need to hang-up) between calls; the user simply presses another {
DSS/BLF}
button.
5. An Intercom call to a station in the HF answerback or Voice Announce mode (H or P
Intercom Signaling Mode) is not considered answered unless the called user lifts the handset
or presses the [
SPEAKER] button (goes off-hook).
Programming
STATION 1. Prime Line (PGM 113-Btn 7)
S
YSTEM 1. ICM Dial Tone Timer (PGM 181-Btn 6)
2. Inter Digit Timer (PGM 181-Btn 7)
Related Features
Intercom Signaling Mode
Speakerphone
Hardware
3.3 INTERCOM CALL HOLD
Description
While on an active ICM Call, users of iPECS Phones can place the ICM Call on hold. The held
station will receive the assigned Music-on-Hold. The call is placed on Exclusive Hold and recalls
to the holding station after expiration of the Exclusive Hold Recall Timer.
To Next Page
Loading...
