LG IPECS - Page 231

IPECS Release 5
Feature Description & Operation 5.0
4-15
record at ring stop
AA : BBBBBBBBCCC : DDDDDDDDD(EEE) -> FFF
record at answer
AA : BBBBBBBBCCC : DDDDDDDDD(EEE) -> FFF
Where:
AA – ISDN CO line number
BB…B – Line Identification received
CCC – Called station
DD…D – Speed Dial name
EEE – Speed Dial bin number
FFF – Answering station
The system will also compare the identification to the Speed Dial bins. If a match exists, the Name
of the Speed Dial bin may be displayed in place of the number, CO/IP Name display.
The system will send calling and answering party identification in the appropriate messages to the
ISDN based on the database. Identification messages may be restricted, not reported, to the far-
end user. Calling Line Identification Restriction and Connected Line Identification Restriction may
be enabled in the system database or by {
CLIR} and {COLR} Flex buttons.
Operation
System
Operation of this feature is automatic.
iPECS Phone
To program {
CLIR} button,
[
PGM] + {FLEX} + [PGM] + ‘81’ + [SAVE]
To program {
COLR} button;
[
PGM] + {FLEX} + [PGM] + ‘82’ + [SAVE]
To activate CLIR or COLR, before placing or answering an ISDN call
1. Press the {
CLIR} or {COLR} Flex button.
Conditions
1. This feature may not be available in the specific ISDN service area or may be a subscription
service.
Programming
STATION 1. CLIP LCD Display (PGM 114-Btn 1)
2. COLP LCD Display (PGM 114-Btn 2)
CO/IP 1. COLP Table Index (PGM 143-Btn 1)
2. Type of Calling Number (PGM 143-Btn 4)