LG IPECS - Page 280

IPECS Release 5
Feature Description & Operation 5.0
6-11
6.10 DAY/NIGHT/TIMED/SCENARIO RING MODE
Description
The system clock automatically controls the Ring Mode. Ring assignments are applied based on
the time of day and day of week. Four modes of ring (Ring Assignments) are provided, Day,
Night ,Timed and Scenario.
The Attendant controls the system Ring Service mode changing from Auto Service Mode to Day,
Night ,Timed or Scenario service mode. Based on the service mode selected, different ring
assignments, COS and answering privileges are invoked for the system users.
Operation
System Attendant
To change Day/Timed/Night Ring Mode manually;
1. Press the [
DND] button.
2. Dial 1~5. (1: Day mode, 2: Night mode, 3: Timed mode, 4: Auto Service mode, 5: Scenario
mode)
3. If you set Scenario mode(5), you should set scenario group(MFIM100/300/600 : 01 ~16,
MFIM1200: ~32).
4. Press the [
HOLD/SAVE] button.
To set Day/Timed/Night Ring/Scenario Mode automatically (Auto Service Mode Control)
1. Press [
PGM] button, [PGM] button LED flashes 60 ipm, [SPEAKER] LED lights steady.
2. Dial the Attendant Station Program code ‘#8’ to toggle between manual and Auto Mode
control.
Conditions
1. Only Attendants can change Day/Timed/Night/Scenario Ring Mode for the system manually
and program the Auto Ring Mode Selection Table.
2. Stations receive incoming ring for CO lines based on the database assignments and the
system mode (Day/Night/Timed/Scenario) when the call arrives.
3. When Auto Ring Selection Table is programmed, the ring, COS and CO/IP access mode are
changed automatically based on the times assigned in the table.
4. The System Attendant always has manual control of the system mode by enabling/disabling
the Auto Service Mode Control.
5. If you want to set manually Scenario mode in attendant, you should program Scenario group
of System call routing table(PGM 251).
Programming
CO/IP 1. CO Line Ring Assignment (PGM 144)
S
YSTEM 1. External Control Contact (PGM 168)
T
ABLES
1. Auto Ring Mode Selection Table (PGM 233)
2. System Call Routing (PGM 251)