EasyManuals Logo

Lucent Technologies DDM-2000 OC-12 Installation Manual

Lucent Technologies DDM-2000 OC-12
382 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
[[YL Issue 5 November 2000
363-206-208
About This Document
Lucent Technologies - Proprietary
See Notice on first page
Safety Instructions
Admonishments
Important safety instructions are in this manual. In addition to the instructions on the
following page, there are other safety instructions you must follow. These instructions
involve lasers, lightwave optical cable and connectors, and precautions when handling
circuit packs to prevent damage from electrostatic discharge. This manual also contain
admonishments in the form of DANGERS, WARNINGS, and CAUTIONS which must be
followed at all times.
These admonishments have the following definitions:
DANGER indicates the presence of a hazard that will cause death or severe per-
sonal injury if the hazard is not avoided.
WARNING indicates the presence of a hazard that can cause death or severe
personal injury if the hazard is not avoided.
CAUTION indicates the presence of a hazard that will or can cause minor per-
sonal injury or property damage if the hazard is not avoided. The caution is also
used for equipment damage, loss of software, or service interruption.
The alert symbol is used on product labels and in this manual to alert the user to
important operating and maintenance instructions.
Lightwave Safety
A Lucent lightwave digital transmission system and associated optical test sets use
semiconductor laser transmitters. The lasers emit lightwaves, at or near infrared
wavelengths, into lightguide cables. This light is at the red end of the visible spectrum.
Although, at present, the transmitter power levels are below those known to cause
injury to the eye; for example, from a direct inadvertent exposure to the end of an
energized fiber, direct exposure at close distances should be avoided.
!
WARNING:
Never view any unterminated optical connector with optical instruments other than
indirect image converting devices such as the FIND-R-SCOPE
*
, since viewing
optics tend to collimate the energy from an optical connector and, hence, increase
the potential risk for injury.
*. Registered trademark of F. J. W. Industries, Inc.
!

Table of Contents

Other manuals for Lucent Technologies DDM-2000 OC-12

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies DDM-2000 OC-12 and is the answer not in the manual?

Lucent Technologies DDM-2000 OC-12 Specifications

General IconGeneral
BrandLucent Technologies
ModelDDM-2000 OC-12
CategoryMultiplexer
LanguageEnglish

Related product manuals