Issue 5 November 2000
363-206-208
Stand-Alone (Local) Installation Tests for the DDM-2000 OC-12 Multiplexer
Lucent Technologies - Proprietary
See Notice on first page
DDM-2000 OC-12 Command Notes
NOTE:
All DDM-2000 OC-12 commands will be issued through the ASCII terminal.
NOTE:
For a list of the DDM-2000 OC-12 command codes refer to Table 6-1 on page 6-
27. A complete list of DDM-2000 OC-12 command codes with their descriptions
is contained in the 363-206-207 (Releases prior to 5), 363-206-290 (Release 5),
or 363-206-295 (Release 7),
DDM-2000 OC-12 Multiplexer User/Service Man-
ual.
NOTE:
Commands can be entered in either upper, lower or mixed case.
NOTE:
If a command is partially entered, or if ? is entered any time, the user will be
prompted with a menu of available choices.
NOTE:
The following special ASCII characters are supported:
Semicolon (;) — the official and preferred huMan-Machine Langauge (MML)
command terminator. Carriage Return, Enter, or Dollar Sign — alternative MML
command terminators.
Question Mark (?) — suspends the present input operation and displays appro-
priate help which requires a user response.
Backspace and Underscore (_) — erases the previous character input.
At-sign (@) — erases the current line.
CANcel and DELete — terminates the current input line.
Hyphen (-) — separates identifiers in the command mode.
Colon (:) — separates parameter blocks in a command.
Comma (,) — separates parameters within a parameter block in a command.
To Next Page
Loading...