COM1 Tab
COM1 Tab
Start | Settings | System | Data Collection | COM1 tab
Factory Default Settings
Baud Rate 9600
Data Bits 8
Stop Bits 1
Parity None
Scanner Control / COM1
Integrated laser scanner default values are 9600 Baud, 8 data bits, 1 stop bit and No parity.
If these values are changed, the default values are restored after a cold boot or after re-imaging the OS.
Note: COM1 does not support 5V switchable power on Pin 9 for tethered scanners.
E-EQ-MX7WMRG-A [ 97 ] MX7 Tecton™ for Windows Mobile Reference Guide
To Next Page
Loading...
