LXE MX7 Tecton - Bluetooth

Bluetooth
Bluetooth
Start | Settings | System | Bluetooth
Note: Contact your LXE representative for upgrade availability if your Bluetooth panels are not the same as the panels
presented in this section.
Discover and manage pairing with nearby Bluetooth devices.
Factory Default Settings
Discovered Devices None
Settings
Turn On Bluetooth Enabled
Computer is connectable Enabled
Computer is discoverable Disabled
Prompt if devices request to pair Enabled
Continuous search Disabled
Filtered Mode Enabled
Printer Port on COM9:
Disabled (unchecked) by default in both Filtered
and Non Filtered Modes. The option is dimmed
in Non Filtered Mode.
Logging Disabled
Computer Friendly Name [System Name]
Reconnect
Report lost connection Enabled
Report when reconnected Disabled
Report failure to reconnect Enabled
Clear Pairing Table on boot Disabled
Auto Reconnect on Boot Enabled
Auto Reconnect Enabled
Bluetooth icon (at the bottom of the Today panel) state and Bluetooth device Icon states change as Bluetooth devices are
discovered, paired, connected and disconnected. There may be audible or visual signals as paired devices re-connect with the
MX7 Tecton.
l The default Bluetooth setting is On.
l The MX7 Tecton cannot be discovered by other Bluetooth devices when the Computer is discoverable option is dis-
abled (unchecked) on the Settings panel.
l Other Bluetooth devices cannot be discovered if they have been set up to be Non-Discoverable or Invisible.
l When Filtered Mode is enabled, the MX7 Tecton can pair with one Bluetooth scanner and one Bluetooth printer.
l When Filtered Mode is disabled, the MX7 Tecton can pair with up to four Bluetooth devices connected at the same
time.
l It is not necessary to disconnect a paired scanner and printer before a different scanner or printer is paired with the MX7
Tecton.
E-EQ-MX7WMRG-A [ 72 ] MX7 Tecton™ for Windows Mobile Reference Guide