Global Parameters
Parameter Default Function
CCX or CCX Features Optimized
Use of Cisco Compatible Extensions (CCX) radio management and AP
specified maximum transmit power features.
This parameter cannot be changed.
WMM Off
Use of Wi-Fi Multimedia extensions.
Options are: On, Off
Default value cannot be changed.
Auth Server Type 1
Specifies the type of authentication server.
Options are: Type 1 (ACS server) and Type 2 (non-ACS server)
TTLS Inner Method Auto-EAP
Authentication method used within the secure tunnel created by EAP-TTLS.
Options are: AUTO-EAP (Any available EAPmethod), MSCHAPV2, MSCHAP,
PAP, CHAP, EAP-MSCHAPV2
PMK Caching Standard
Type of Pairwise Master Key (PMK)caching to use when WPA2 is in use. PMK
caching is designed to speed up roaming between APs by allowing the client
and the AP to cache the results of 802.1X authentications, eliminating the need
to communicate with the ACS server. Standard PMK is used when there are no
controllers. The reauthentication information is cached on the original AP. The
client and the AP use the cached information to perform the four-way handshake
to exchange keys. Opportunistic PMK(OPMK) is used when there are
controllers. The reauthentication information cached on the controllers. The
client and the controller behind the AP use the cached information to perform the
four-way handshake to exchange keys.
If the selected PMK caching method is not supported by the network
infrastructure, every roam requires full 802.11X authentication, including
interaction with the ACS server.
If the active profile is using WPA2 CCKM, the global PMKCaching setting is
ignored and the client attempts to use CCKM.
Options are: Standard, OPMK
Note: This change does not take effect until after a Suspend/Resume
cycle.
WAPI Off Default is Off and dimmed (cannot be changed)
TX Diversity On
How to handle antenna diversity when transmitting packets to the Access Point.
Options are: Main only, and On.
RX Diversity
On Start
on Main
How to handle antenna diversity when receiving packets from the Access Point.
Options are: On-start on Main, and Main only
Frag Thresh 2346
If the packet size (in bytes) exceeds the specified number of bytes set in the
fragment threshold, the packet is fragmented (sent as several pieces instead of
as one block). Use a low setting in areas where communication is poor or where
there is a great deal of wireless interference.
This parameter cannot be changed.
RTS Thresh 2347
If the packet size exceeds the specified number of bytes set in the Request to
Send (RTS) threshold, an RTS is sent before sending the packet. A low RTS
threshold setting can be useful in areas where many client devices are
E-EQ-MX7WMRG-A [ 264 ] MX7 Tecton™ for Windows Mobile Reference Guide
To Next Page
Loading...
