MASSO G2 - Page 125

MASSO
MASSO Documentation
Step 8: Go back to F4-Tools & Work Offset screen and enter the measured diameter value in Test Piece
(Dia) box and click Touch button.
CAUTION: Make sure to select the position of the tool depending if its installed on the front or the
back side.
Step 9: Next select if the tool is on the front side or the back side and make sure that the Z Wear and X
Wear values are 0.00.
v5.18 - 08 Apr,2021
www.masso.com.au Page 125 of 477