MASSO
MASSO Documentation
8.13. G30 - Move to Parking Position
CAUTION: This command can be used in different combinations and wrong command can result
in unexpected rapid motion. Depending if the machine is in Absolute or Incremental mode the
behavior of G30 command will be very different, extra caution should be used when using this
command.
This command is used to move the Machine to the defined Parking position
At times users may wish to have a dedicated park location to move the Spindle to, so that it is out of
the way when loading and unloading material.
Syntax & Parameters
G30 - This first rapids the Z axis to its specified parking position and then the remaining axis will
simultaneously move to their parking positions.
The Park position is defined in the F4 Screen
Example program for moving all axis to Parking position
N10 G30
Defining the Parking Position
The Parking Position is defined in the F4 Screen using Machine Coordinates.
v5.18 - 08 Apr,2021
www.masso.com.au Page 210 of 477
To Next Page
Loading...
