MASSO
MASSO Documentation
9.18. M64 – Turn On Digital Output Immediately
This command is used to switched ON any of the 16 auxiliary outputs. If this command is used between
motion commands then the motion will come to full stop before switching ON the output.
Syntax & Parameters
M64
P Value - The P value is required and defines the output number to switch On. This value can be
between 1 to 16.
Example program
N10 M64 P1 N20 M64 P4
The N10 line will switch ON the auxiliary output 1.
The N20 line will switch ON the auxiliary output 4.
INFORMATION: For M64 P# to work you must assign an output as an auxiliary output in F1-Setup
screen under OUTPUTS list.
v5.18 - 08 Apr,2021
www.masso.com.au Page 254 of 477
To Next Page
Loading...
