MASSO
MASSO Documentation
9.4. M03 – Spindle ON (Clockwise)
This command starts the spindle in clockwise direction at the RPM set by the S command
Syntax & Parameters
M03 - Clockwise command followed with or without S value.
S - The S value defines the required RPM. If the S value is not given then the last S value is
automatically used.
Example program
N10 M03 S1200
In this example the spindle is started in clockwise direction at 1200 RPM.
v5.18 - 08 Apr,2021
www.masso.com.au Page 239 of 477
To Next Page
Loading...
Need help?
General
