MASSO
MASSO Documentation
11.7. Setting default units to mm or inches
Setting default units of the controller
As per the user requirements the default machine units can be set between millimeters or inches in the
controller settings. All controller calibration values and screen units are displayed as per the selected unit.
The machine units settings is available in the F1-Setup screen under General Setting window.
INFORMATION: The controller units can also be temporarily changed between millimeters or
inches using G20 and G21 gcodes.
v5.18 - 08 Apr,2021
www.masso.com.au Page 325 of 477
To Next Page
Loading...
