MASSO
MASSO Documentation
9.17. M63 – Turn Off Digital Output Synchronized With Motion
INFORMATION: From MASSO software version 3.47, to use M63 command please use M65
command as M63 command has been changed.
INFORMATION: MASSO G2 does not support M63 command from version 3.47, please use M65.
This command is used to switched OFF any of the 16 auxiliary outputs synchronized with the start of the next
motion command.
CAUTION: If no motion is commanded, the output will not turn OFF. It is best to specify motion
immediately following the M63 command.
Syntax & Parameters
M63
P Value - The P value is required and defines the output number to switch On. This value can be
between 1 to 16.
Example program
N10 G0 X0 N20 M62 P1 N30 X10 N40 M63 P1 N50 X20
In the above example the the X axis moves to X0 position, then auxiliary output 1 is turned ON when
the X axis starts to move towards X10 position. Once the axis reaches X10 position and starts
moving to X20 position, the auxiliary output 1 is turned OFF.
INFORMATION: For M63 P# to work you must assign an output as an auxiliary output in F1-Setup
screen under OUTPUTS list.
v5.18 - 08 Apr,2021
www.masso.com.au Page 253 of 477
To Next Page
Loading...
