MASSO
MASSO Documentation
9.9. M06 – Tool Change
WARNING: When using an auto tool changer the M06 must be preceded by an M05 or the
drawbar will not release and can result in damage to the tool changer.
CAUTION: This command can be used in different combinations and wrong command can result
in unexpected loading of tool.
INFORMATION: Valid tool numbers are T0 to T99
This command is used to change tool immediately and can be used with T value.
Syntax & Parameters
M06
T Value – specifies the tool number to change, this value can be used before M06 or after M06 but
will have a very different process of tool loading.
Scan the QR code to watch the MASSO video tutorial on YouTube
Or, Click here to view the video
Example program
N10 M05 N20 T5 M06
In above program the M05 stops the spindle then T5 tells the system that we would like to load tool number
v5.18 - 08 Apr,2021
www.masso.com.au Page 244 of 477
To Next Page
Loading...
