MASSO
MASSO Documentation
13. Touch Probe
A wired or wireless touch probe can be wired to MASSO to be used with interactive part probing or with
G38.2 probing cycle gcode command.
INFORMATION: For information about interactive part probing CLICK HERE
INFORMATION: For information about using G38.2 probing cycle CLICK HERE
Wiring the probe
The probe signal can be wired to one of the inputs on the MASSO. The voltage signal from the probe must
be between 5 to 24v.
Wiring example of Drewtronics Probe
v5.18 - 08 Apr,2021
www.masso.com.au Page 389 of 477
To Next Page
Loading...
