MASSO
MASSO Documentation
8.30. G96 – Turn on Constant Surface Speed (CSS)
This command is used to enable Constant Surface Speed (CSS) mode in lathe version.
Syntax & Parameters
G96 followed by D & S values.
D Value - This is to set the maximum spindle RPM that the spindle can achieve in CSS mode as the
tool gets closer to the center.
S Value - To set surface speed value. The units will be the current machine units in use.
Example program
N10 G96 D2000 S200
In the above example CSS mode is enabled with a surface speed of 200 and the maximum RPM is
set to 2000.
INFORMATION: Units are defined as either inches or mm depending on your machines setup or
G20 or G21 command in use.
v5.18 - 08 Apr,2021
www.masso.com.au Page 228 of 477
To Next Page
Loading...
