MASSO
MASSO Documentation
9.1. M00 – Program Stop
This command stops the program. Pressing cycle start will resume the program.
Syntax & Parameters
M00
Example program
N10 G00 X0 Y0 N20 G00 X10 N30 M00 N40 G00 Y10
The first line will move both X and Y axis to 0.00 position.
In line two the X axis will move to X 10 position.
In line three the program will stop and wait for user to press cycle start.
v5.18 - 08 Apr,2021
www.masso.com.au Page 236 of 477
To Next Page
Loading...
