MASSO G2 - M02 - Program End

MASSO
MASSO Documentation
9.3. M02 – Program End
This command ends the program.
Syntax & Parameters
M02
Example program
N10 G00 X0 Y0 N20 G00 X10 N30 M02 N40 G00 Y10
The first line will move both X and Y axis to 0.00 position.
In line two the X axis will move to X 10 position.
In line three the program will stop and will not run line four.
v5.18 - 08 Apr,2021
www.masso.com.au Page 238 of 477