MASSO
MASSO Documentation
5.3. Powering MASSO-G2
CAUTION: Semiconductor parts inside the unit can be damaged by electrostatic discharge (ESD).
When handling, care must be taken so that the devices are not damaged. Damage due to
inappropriate handling is not covered by the warranty.
The MASSO power supply connector is located at the top-right corner of the controller as seen in the picture
below. MASSO requires a power supply between 12 and 24 VDC with a minimum of 1.5 Amps output.
MASSO will power on instantly once power is connected.
v5.18 - 08 Apr,2021
www.masso.com.au Page 42 of 477
To Next Page
Loading...
