MASSO
MASSO Documentation
8.6. G10 – Set Work Offset Values
This command is used to set work offsets values to different offset locations.
Syntax & Parameters
L2 Value - Must be issued with G10.
P Value - The P value is required with G10 and it define the work offset number to change between
G54 and G59.
P0 is used to set G54 work offset.
P1 is used to set G55 work offset.
P2 is used to set G56 work offset.
P3 is used to set G57 work offset.
P4 is used to set G58 work offset.
P5 is used to set G59 work offset.
X, Y, Z, A, B Value - specifies the axis you wish to offset following the distance value. The distance
value will be the current machine units in use.
Example program
N10 G10 L2 P0 X10 Y10
The above program will add add 10 millimetres to the X and Y axis G54 offset.
INFORMATION: Units are defined as either inches or mm depending on your machines setup or
G20 or G21 command in use.
v5.18 - 08 Apr,2021
www.masso.com.au Page 202 of 477
To Next Page
Loading...
Need help?
General
