MASSO
MASSO Documentation
9.14. M11 – Chuck Or Rotary Table Clamp Off
This command turns Off the Chuck Clamp output.
CAUTION: For safety this output HIGH means the clamp is Off and an interlock signal from the
spindle drive must be wired for safety so that the clamp does not open while the chuck is spinning.
Syntax & Parameters
M11
Example program
N10 M11
In this example the Chuck Clamp is switched Off.
v5.18 - 08 Apr,2021
www.masso.com.au Page 250 of 477
To Next Page
