MASSO
MASSO Documentation
16.2.4. EMCO PC55 Turn
This 6 station turret outputs two control signals. The first signal is the home position signal which tells the
system that the first tool is in position. The second signal is the pulse signal, this signal pluses once on each
tool change and is used to count tool number position as the turret turns.
Setting up the tool changer
Go to F1-Setup screen and open Tool Changer window.
From the list select Press enter to open Tool Changer list and select the the EMCO PC55 Turn - 6
Station Turret from the list.
v5.18 - 08 Apr,2021
www.masso.com.au Page 431 of 477
To Next Page
Loading...
Need help?
General
