EasyManuals Logo

MASSO G2 User Manual

MASSO G2
477 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #230 background imageLoading...
Page #230 background image
MASSO
MASSO Documentation
8.32. G98 – Canned Cycle – Retract Back To The Initial Z
This command is used in combination with canned cycles to retract Z axis to the position before canned
cycles was started.
Syntax & Parameters
G98
Example program
N10 G98 G73 X10 Y10 Z-8 R2 Q1 F100
In the above program, after finishing the drilling cycle the Z axis will retract back to the position before
the drilling cycle.
v5.18 - 08 Apr,2021
www.masso.com.au Page 230 of 477

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MASSO G2 and is the answer not in the manual?

MASSO G2 Specifications

General IconGeneral
BrandMASSO
ModelG2
CategoryController
LanguageEnglish

Related product manuals